+- Carolina Broncos (https://cb4x4.com)
+-- Forum: 66-96 Ford Broncos (https://cb4x4.com/forum-7.html)
+--- Forum: Bronco Talk (https://cb4x4.com/forum-39.html)
+--- Thread: New Project started today (/thread-2783.html)
New Project started today - broncosbybart - 05-22-2011
alright. that is just not fair to talk like that and have nothing to show us. BRING ON THE PICS!!! We need ideas to steal (er copy)
New Project started today - shon - 05-23-2011
:thefinger:
New Project started today - 744x4 - 05-23-2011
Here are a few to see where I started.It will be narrowed 8-10 in and as you can see i dropped the drivers side Floor also.I am re-using the taillight Housings to finish the back of the tub but the Body lines will match once I am done.I cut the hard top also but I havent cut the back portion yet .
New Project started today - 744x4 - 05-23-2011
It will be a Mini 1/2 cab once done.Havent decided on the Mini Bed yet but may later.There will actually be some useable room Behind the seat once complete.The back will be solid and follow the stock lines also.
New Project started today - Crawdad - 05-23-2011
Ahhh that sounds like you are wanting to fab up a 3/4 hard top!!! I really wanted to try and cut one up but I figured it would take me 10 years to start. So I sold it this past weekend for a $100. It had a lot of pin holes in the front. If I had my way I would like to have a 3/4 hard top with the very back from a 1/2 cab. Man I sure gotta mind on me! Good luck!:beer:
PS: Here was where my ideas came from!
New Project started today - SC74 - 05-23-2011
We also have two extra rear quarters (or the top where it rolls into the bed) that will be used to wrap the back and the body line will be consistent around the back.
New Project started today - broncosbybart - 05-23-2011
You are getting a lot done. Thanks for the pics! Keep em' coming.
New Project started today - NGABronco - 05-23-2011
Just a word from a guy that wanted to do that to a top!! The front (at door) is 21" and the rear is 20-1/2" or some where abouts!!! There's about 1/2-3/4" difference!!! Go measure!!!!
My ideas came from here, but then I got the tape out!!!!
New Project started today - 744x4 - 05-24-2011
It wont matter as I am narrowing the top/body also so there will be a 8-10 in gap to play with to get it right.
New Project started today - 744x4 - 05-24-2011
drivers corner done