+- Carolina Broncos (https://cb4x4.com)
+-- Forum: 66-96 Ford Broncos (https://cb4x4.com/forum-7.html)
+--- Forum: Bronco Tech (https://cb4x4.com/forum-40.html)
+--- Thread: dana 20 t-shift help (/thread-1786.html)
dana 20 t-shift help - snipes243 - 08-18-2009
Ok guys im rebuilding my t-shift and i cant seem to get the snap ring off the front output shaft, the bearing is in the way. Does anybody know any tricks to get it off?
dana 20 t-shift help - broncomatt - 08-18-2009
Its been a long time since I've had mine apart, and I'm not near my spare one too look at so I'll have to guess. I remember taking the yoke nut off, pulling the yoke, unbolting the plate on the back and gettting it apart from there. Hope that helps, if not I can look when I get home. Do you have a manual or a diagram? I also used case ring plyers to rebuild mine. Be sure and have some of those.
Broncomatt
dana 20 t-shift help - snipes243 - 08-18-2009
I think I got it matt, The bearing in from of the snap ring, it was giving me the most problem but i finally got it off.