+- Carolina Broncos (https://cb4x4.com)
+-- Forum: 66-96 Ford Broncos (https://cb4x4.com/forum-7.html)
+--- Forum: Bronco Talk (https://cb4x4.com/forum-39.html)
+--- Thread: 5-point harness with 2" webbing? (/thread-2537.html)
5-point harness with 2" webbing? - chuzie - 12-27-2010
I am looking for a 5 point harness to replace my 4 point because each time I cinch the shoulder straps the lap section rides up on my stomach and my seats do not have holes to retain the lap. I like the 2" because it is easier to adjust than the thick 3" raching stuff I see out there. Since I am not racing I don't see a need for all this thick 3" overkill.
Anyone know of a 5-point harness with 2" webbing?
Thanks.
5-point harness with 2" webbing? - abunchofidiots - 12-29-2010
Crow,Simpson, G-force, and a few others make them. They are listed under "junior racing harness" or similar in order to get the 2" stuff.
5-point harness with 2" webbing? - chuzie - 12-29-2010
abunchofidiots Wrote:Crow,Simpson, G-force, and a few others make them. They are listed under "junior racing harness" or similar in order to get the 2" stuff.
Do you remember the name of the place or brand of the belts you sold me?
5-point harness with 2" webbing? - abunchofidiots - 01-03-2011
Its been a while, but I think the brand was G-force. I had ordered them from JC Whitney or Summit with the seats.
5-point harness with 2" webbing? - abunchofidiots - 01-03-2011
Instead of replacing those, have you thought of adding a sub-belt loop to the seat frame? Its just a loop that goes around the center clip and ties into the seat frame similar to whats found on the twisted stitch seats.
I'm actually looking to get or make something similar that just velcros around the lap belt and ties into the seat. It will not be to augment the seat belt, just to keep it from riding up in my superduty.
5-point harness with 2" webbing? - chuzie - 01-03-2011
Do you know where I would find them? Tht may be a great option.
5-point harness with 2" webbing? - abunchofidiots - 01-04-2011
If you have a rigger shop over on base, that would be the first option to have one made. Otherwise, I am keeping my eye out for something similar.