tilt column

[berg bronco]

im looking to buy a tilt column for my bronco i have the floor shift and a t.b.p. steeering weel and have power steering with a ujoint steering shaft. wich bronco vendor sells the best setup and how hard is the install i already have the stock column out im just trying to decide who to go with!

[firefighter2134]

I got mine from toms few yrs ago. Prolly about an hr and half install.

[berg bronco]

I got mine from toms few yrs ago. Prolly about an hr and half install.

what kinda wheel you have on it

[firefighter2134]

the bronco logo wheel. i bought the complete kit. the wheel uses a grant adapter kit

[broncosbybart]

I had one of Tom's units as well, was a complete kit with their Bronco logo wheel. Not too bad to install. I had to modify the firewall column support clamp, as the aftermarket columns are a smaller diameter than the stock column. Otherwise, no problems (provided you get their kit). You can piece it together, if you already have some of the parts.

[berg bronco]

do you guys find that you use the tilt that much?

[broncosbybart]

personally, no. set it and forget it...

[firefighter2134]

yup. Set it and forget it. But in same sense its nice to be able to tilt it up to get easier access under the dash

[berg bronco]

yup. Set it and forget it. But in same sense its nice to be able to tilt it up to get easier access under the dash

i didnt think of that!