Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
New Im in Pikeville
#11
Love the wood visor shelf. Was it hard to make?
Dave
[SIGPIC][/SIGPIC]
VIN# makes it a 1985, the engine block# is an 1989, and the front end is from a 1987. I call it Broncenstein. [Image: bronco.gif]
Reply
#12
Not at all just think about how you want to mount it. That was the hardest part. I didn't use brackets the roof is double wall so we used some short screws and drilled into it. And put it directly up as close as I could get it but still have room. Some people have uses brackets or made some that allow you to screw into the visor holes. All depends on what you want. Btw the shelf in the back held me (210lbs) no problem

Sent from my SCH-I535 using Tapatalk 4
Is that a tank?....NO...its worse....Its my Bronco
Reply
#13
Looking good. My favorite big bronco year keep the mods going and the pictures coming 👍
Reply
#14
Found this bad boy at a junk yard last week. Lots of parts to pick if you are near 95 at SC/NC border.


Attached Files Image(s)
   
[SIZE="2"]77 project bronco w/ 5.0 & c4, Sagi PS, 2 hard tops, eyebrow grill [/SIZE]
WANTED: auto column, gas tank, front/ rear seats
Reply
#15
That looked sas! You willing to pull springs and ship? I'd be willing to pay you for labor of course. And where about near the boarder? I'm an hour or so from it

Sent from my SCH-I535 using Tapatalk 4
Is that a tank?....NO...its worse....Its my Bronco
Reply
#16
So I picked up this bad boy yesterday. Pulled for me at the local pull yard $75 as is. You can't beat that all I had to do was bring yhr trailer.

[Image: 8yde5asy.jpg]
[Image: datahytu.jpg]

Sent from my SCH-I535 using Tapatalk 4
Is that a tank?....NO...its worse....Its my Bronco
Reply
#17
So needless to say I plan on riding high and getting setup for a lot of wheeling. In a few months anyone want to lend a hand with installation?

Sent from my SCH-I535 using Tapatalk 4
Is that a tank?....NO...its worse....Its my Bronco
Reply
#18
That's awesome, great deal!!! I would if you were closer

Sent using my HTC ONE via Tapatalk
77 built 306,Trickflow Cam/Alum Heads/dome pistons/10:1comp,nv3550,duff long arms,3.5" lift,family cage,protofab rear bumper,twin sticked, and 35KM2'sG.D.I.
Reply
#19
Sweet. Wish I lived closer.
[SIGPIC][/SIGPIC]
VIN# makes it a 1985, the engine block# is an 1989, and the front end is from a 1987. I call it Broncenstein. [Image: bronco.gif]
Reply
#20
Ron, I got 6" lift Deaver coils that would fit nicely on that new axle! Think about it.

Sent from my Galaxy S3
[SIGPIC][/SIGPIC]
79 FS 351M, Trac loc HPD44, Detroit 9", 4.56's, 37 Toyo's, 17" Helo Maxx 6
Reply


Forum Jump:


Users browsing this thread: 10 Guest(s)