what have you wrenched on your bronco(s) today?

[jdowns67]

Horn started blowing by itself today. I am always worried about fires so I tore it down as soon as I got home. Contact pin wore slap out and spring came off. Anyone know the correct term for this part so I can buy another one?

[blazinchuck]

im not sure what those small parts are called...i can tell you the replacement switch is mainly junk. havent been happy with the few ive installed. id try a pull a part and see if they have an old ford you can rob the parts from

[jdowns67]

Yea I figured out that it's actually part of the turn signal switch which I really don't feel like replacing.

[Broncitis]

Got the wheel bearing pressed on and the axle put back in and am mobile again.

[blazinchuck]

good job dwight

[Broncitis]

So many things I need to attend to and trying to figure out what to get at next. So today I just road some of the back roads in the bronc for awhile and then picked up a friend and let him drive me for a bit. Locker or new roll bar to fit the half cab or 435 or what to do next. I did pick up a stock rim today and got a used 33 inch spare. So today other that finishing the axle bearing I just spent some time trying to get a plan together. Maybe tomorrow I will iron one out.

[blazinchuck]

i would say 435....gearing is the best option!!! that posi in the back worked perfect! then cage/halfcab

[Broncitis]

Awight Clay you hear the man. I will be ready to pic the 435 up when you are available. Thanks for giving me some direction on how to proceed Chuck.

[blazinchuck]

No problem Dwight, control makes all the difference, any time you can go with gearing...that's the way to go. Now, instead of possibly slipping a clutch, you'll be able to crawl

Sent from my HTC6500LVW using Tapatalk 2

[wepuckett]

Found a set of 33x12.5x15 wheels and tires with 25% tread 2 are 8 in wheels and 2 are 10 in wheels, 2 hold air and 2 i need to put air in to see if they hold for $20 tonight picked them up so I can see the size on the Bronco with the lift on it, gonna wait till engine is in to put them on due to clearance in the garage.