what have you wrenched on your bronco(s) today?

[Broncitis]

Replaced the idiot light type oil pressure sending unit with a gauge type. Looked a bit closer at what is gonna need to be done and where the shifter will be coming thru the floor when I put the 435 in.

[chuzie]

Good. No shove this in your rear end!

http://classicbroncos.com/forums/showthr...p?t=255619

Sent from my GS3 on Cyanogenmod with the older / better version of Tapatalk!

[Broncitis]

Moved the 435 into the shop and made some room to get started on putting it in and found that something in the shifter or trans is froze up. Guess I will pull the shifter tomorrow and see if I can figure out what in binding it. No side to side and no forward movement.

[snipes243]

Moved the 435 into the shop and made some room to get started on putting it in and found that something in the shifter or trans is froze up. Guess I will pull the shifter tomorrow and see if I can figure out what in binding it. No side to side and no forward movement.

Pull the shift collar off, It probably didn't get lined back up right when I had too take it off to remove the trans.

[Bronco Biff]

I need to snap a picture this evening for proof and post it up but to get ya guessing I changed the plugs and bolted on a 100 HP to the lil' 289 Sunday finally getting something done that has been sitting around in my garage since the late '80s....(or make that garages because I've moved 1 time too!) ....Dang, meant to snap a shot of the vintage box before it went away with the recycle stuff today!! Take your best guess!!

[wepuckett]

Cold air intake or alluminum intake?

[ncsubronc]

Paxton Supercharger?

[chuzie]

The essence of a thousand kittens mixed with bits of ground unicorn spike?

Sent from my GS3 on Cyanogenmod with the older / better version of Tapatalk!

[Broncitis]

I pulled the top off the 435 and figured out how to get the shifter timed with the gears and reinstalled it and it shifts now. The small nylon clips (edited/Shift Fork Inserts) for lack of a better name for them which are located on the 1-2 and 3-4 forks are deteriorated so I am gonna see if I can find some to replace them before putting transmission in. On a side note the gears all look perfect with no signs of chipping.
I did ride a lil short local trail this afternoon and idled thru some mud. When it started getting deep I turned around and came out cause I was alone and have not acquired a winch yet. Think I may order a
Smittybilt this evening.

[chuzie]

Chuck has a smitty he may be looking to sell. Hit him up

Sent from my GS3 on Cyanogenmod with the older / better version of Tapatalk!