09-05-2008, 12:58 PM
I appreciate the offer, Travler! I was about this close --><-- to shipping them up to Dale and asking him to take the to the shop he used.
I got a tip from one of my dad's co-workers about a shop he's used for driveshaft work before. Dropped my shafts off at a small machine shop down in Claxton, Georgia. Owner/only employee sounded like it would be no problem to lengthen/shorten them. He gave me an estimate of $45 to shorten the front shaft 10.5" and $150 to lengthen the rear by 13 13/16. Not too bad, i think...
I got a tip from one of my dad's co-workers about a shop he's used for driveshaft work before. Dropped my shafts off at a small machine shop down in Claxton, Georgia. Owner/only employee sounded like it would be no problem to lengthen/shorten them. He gave me an estimate of $45 to shorten the front shaft 10.5" and $150 to lengthen the rear by 13 13/16. Not too bad, i think...
'95 Bronco -- 351W-435-205, D44 SAS, Cromos, Truetrac, E-Locker