10-26-2007, 11:28 PM
BroncJr Wrote:Hey y'all, just wondering if anyone is running this driveshaft or maybe what it was taken off of. Just curios if it was stock or aftermarket/Custom. There isn't any part numbers, just a warning sticker. Also it has a chip in the flange wondering if it still looks usable. Very, very broke to buy flange.
still a little slow in getting pics to upload on forum post. If you want to look at the shaft then see my gallery.
thanks again y'all for any and all help!
I checked out those pics, I cant tell ya if its stock to a BII, but I would think its still usable even with the chip. Just check to see if there is slop in the slip yoke(has splines) not in and out, but rotational. Also check the cv joint for wear.Chuck
77 built 306,Trickflow Cam/Alum Heads/dome pistons/10:1comp,nv3550,duff long arms,3.5" lift,family cage,protofab rear bumper,twin sticked, and 35KM2'sG.D.I.