06-15-2009, 10:15 PM
Just a quicky without starting a tech thread.
Bronco axles are stubborn. One side is a 1/2 shorter than the other. Make sure you have them on the correct side.
Sometimes you have to push them in till it stops, pull it out a bit, rotate 10 degrees and try again.
If you go around 360 deg, 10 deg at a time and you don't find the sweet spot, start a tech thread and let everyone weigh in.
I'm sure we can figure it out.
Bronco axles are stubborn. One side is a 1/2 shorter than the other. Make sure you have them on the correct side.
Sometimes you have to push them in till it stops, pull it out a bit, rotate 10 degrees and try again.
If you go around 360 deg, 10 deg at a time and you don't find the sweet spot, start a tech thread and let everyone weigh in.
I'm sure we can figure it out.