07-13-2009, 05:01 PM
I have a front disc setup on my '77. The two proportioning valves I pulled out of my shed have one difference that I can see and that is the lower part on the valve on the right seems shorter and wider than the one on the left. Also, I could not pull any numbers off the one on the left but the one on the right did show D6 as part of the casting number so I know it is a 76 model.
My question is, is there a better choice between the two or are they basically the same?
I am determined to squash this brake issue today!
Sorry for the crappy pic.
Thx,
Mike
My question is, is there a better choice between the two or are they basically the same?
I am determined to squash this brake issue today!
Sorry for the crappy pic.
Thx,
Mike
'77 351w- Explorer EFI, 4R70W, 4-link, lockers, 4.56, 35" MT/Rs with a severe rock addiction.
mokin:
Roads? Where we're going, we don't need roads.
![[Image: sig2.jpg]](http://i288.photobucket.com/albums/ll176/mchuzie/sig2.jpg)
mokin:Roads? Where we're going, we don't need roads.