Roll Cage Measurements

[SC74]

robert-why not bend your "x" bar so that it tapers down 2.5" at each end, so it still ties into the main cage yet creates the 2.5" of more head room? I guess I need to look at your pics to see if this is possible.

I could do that. My entire cage rakes from the back down to the front. I guess it would be a 2.5" rise in the front and about a 1.5" rise in the back, but it could be done. There's a lot of tube wasted on bends like that though b/c to get that little neck of a turn down you've got to bend an extra foot of tube to get that full bend sense it is at the end of the tube.