04-05-2010, 12:40 PM
got a few things done. got slider mounted and operational and put the rest of the trim on it. i pulled out the awning to look at it and let it air out. i am missing a leg on it and one of the feet are broken. i got all the DP mounted on the drivers side. I sealed and mounted the electrical inlet flange and the phone and 2 cable hookups. i mounted the pass thru door and figured i would try my luck with running a bead around it. it came out good. I used to work with silicone a lot and was pretty good at running beads but you loose it if you dont do it. i also went ahead and sealed the top and 1st seam of the DP. came out really well im happy. i got one side of the slide done and am about to go eat then start the other side of the slide. i would like to get all the DP mounted and sealed today.
the piece at the top i am missing from the other side.
this is the foot of the awning. it is supposed to have a piece between the arrows thas broken
the piece at the top i am missing from the other side.
this is the foot of the awning. it is supposed to have a piece between the arrows thas broken
Eric. :rebel: