04-16-2013, 09:09 AM
The heat sheilds will be a combination of alumium pannels and store bought stuff from Summit.
Weleded in the last of the repair pannels, smothed them out with a flap disk. Painted every surface that you cant get to when its upright. Yes there is a bare spot in the back, that is where a hole will be cut for my fuel cell. The frame is done and now I need to set the tub back onto it. I also need to pick up the cage tubing and plate steel for the cage tie mounts. Before I start on the outer body work I will tie in the cage to the frame.
I'll be cutting and installing the aluminum pannels later today.
Still driving Pe'pe for the time being, I do have the front fenders to clean up and mount, 2 sets of doors to prep and a tailgait to prep. So I can do quiet a bit before I have to tear it all apart to switch it over.
:popc1:
Weleded in the last of the repair pannels, smothed them out with a flap disk. Painted every surface that you cant get to when its upright. Yes there is a bare spot in the back, that is where a hole will be cut for my fuel cell. The frame is done and now I need to set the tub back onto it. I also need to pick up the cage tubing and plate steel for the cage tie mounts. Before I start on the outer body work I will tie in the cage to the frame.
I'll be cutting and installing the aluminum pannels later today.
Still driving Pe'pe for the time being, I do have the front fenders to clean up and mount, 2 sets of doors to prep and a tailgait to prep. So I can do quiet a bit before I have to tear it all apart to switch it over.
:popc1:
[SIGPIC][/SIGPIC]