01-03-2011, 06:50 PM
Today was a good day. A lil chilly, but my ole PT gear did keep me warm enuff. I was able to install my new shorty headers with a few explicit words and some bloody fingers. Before I installed, I took 2 pics of the #1) passenger side shorty after I added some "dimples" to passenger side. The #2) drivers side shorty already had the dimples provided by mfg. On the passenger side I think I will need a new oil dip stick (any good ones out there???) since it is bent badly and thye stick wont go in. I tried to remove it but I do not have a good set of brake wrenches. I will probably need to replace tranny lines since I think I might have crimped one, I'd rather be safe than sorry. Heck I forget the spark plug wiring scheme. I just pulled them with no thought of writing them down back in October. I'm sure I will find a thread on how to do it all over when I install the sparkplugs next weekend. Once the Shortys were in I put on the exhaust, again with a few explicit words and a mouthful of greasy dirt. I like the pre-made system, fit pretty darn well for a $100. Then I put on the muffler and it went in pretty easy. Once I tightened all the bolts the system held itself well although I plan to add some hangers for better support. All in all my hands hurt but I am happy with the results. Hope ya'll like it too.
Next job is installing the new longer SS brake lines.
Next job is installing the new longer SS brake lines.
[SIZE="2"]77 project bronco w/ 5.0 & c4, Sagi PS, 2 hard tops, eyebrow grill [/SIZE]
WANTED: auto column, gas tank, front/ rear seats
WANTED: auto column, gas tank, front/ rear seats