My little mule, Pe'pe

[broncomatt]

Since I'm avoiding cutting the aluminum sheet right now (its loud), even with my ear muffs on so I worked on opening up the rad support. I origanly was going to make one from 1" square stock, but that was the old tub that didnt have any inner fenders or rad support. Since this one has one I opened it up, may cut some more tomorrow. I will need to notch the old battery mount ribs. They are too tall to fit my trans coolers and fans. Still undecided if I will use the fans I have (the ones in the pic) or go back to the 10" pullers I used originaly. The ones in the pic are pushers and are 3/4" thicker which makes fitting them in harder. The pro to these is I have a bunch (8 to be exact) and they were free.
I will need to fab all new mounts for the coolers and the radiator since this was a 6cyl tub. Of course once all the coolers, radiator and fans are mounted I may need to fill in some gaps between things to maximize air flow.