Installing new Edelbrock intake & carb

[Crawdad]

you can get a 1/8 brass tee and reuse the stock elec oil sender and screw the mechanical oil line to the other side of the tee...if you do this, you wont need that larger brass adapter.

i would also consider a butt connector in place of that wire nut...my.02

I will head to Lowes and look for a T! Thx Chuck! I'd like to keep both guages if I can. As far as the wire nut I just wanted to be sure that was a correct wire. For all I know it may be a 12 volt or a 6 volt wire??? The directions say 12 volt so I really need to make sure with a volt meter. After that the butt connecter with heat shrink will be used! Thx again Chuck!:xyxthumbs: