04-18-2011, 10:43 PM
Next, I took the middle pieces and set them all in a bench top vice. I needed to notch them for the hose clamps that will be attaching them to the vehicle. I measured the hose clamps that I'd be using. They were 5/8" wide, so I made the slots 3/4" wide for some extra room. I started each groove 1/2" from each end.
Oh, and unlike what I did, you want to notch the middle pieces on the long side that has the sharp corners, not the rounded corners. In my haste, I forgot to think...
Oh, and unlike what I did, you want to notch the middle pieces on the long side that has the sharp corners, not the rounded corners. In my haste, I forgot to think...