04-18-2011, 10:57 PM
The quick release pins came from Speedway Motors. They are part #910-32841. They were about $5 each and have little detent balls that keep them in place. They will only release when the button in the middle of the pin is pushed and the pin slid out at the same time. They measured exactly 0.250", so I drilled all the holes with a 1/4" bit.
I could have used 2 pins per mounting bracket, but was cheap, so only used one and the other will have a groove cut in the middle plate. Follow along...
I could have used 2 pins per mounting bracket, but was cheap, so only used one and the other will have a groove cut in the middle plate. Follow along...