04-18-2011, 11:12 PM
(This post was last modified: 04-18-2011, 11:14 PM by broncosbybart.)
The pins cut from the 1/4 bolts were plug welded to the flat plates, so that they don't fall out.
When it is finished, it will look like the pics below.
The brackets are attached to the cage and to the extinguisher with hose clamps. I used a #48 size clamp on the extinguisher. Just about any common size clamp can be used on the cage. These are 2.5 lb extinguishers, FYI. It only takes about a second to remove them from the vehicle now. I have about $15 in material for these things. I hope that my explanation of how I made them is somewhat comprehendable...
When it is finished, it will look like the pics below.
The brackets are attached to the cage and to the extinguisher with hose clamps. I used a #48 size clamp on the extinguisher. Just about any common size clamp can be used on the cage. These are 2.5 lb extinguishers, FYI. It only takes about a second to remove them from the vehicle now. I have about $15 in material for these things. I hope that my explanation of how I made them is somewhat comprehendable...