04-21-2011, 10:32 AM
if you decide to cut more, here is a little hint- get a 4-1/2 inch angle grinder if you don't have one already and buy some really thin (0.045') metal cutting wheels for it. that would work a lot better than a jigsaw. i put masking tape over the wheel opening and draw the outline of the fender flare on it with a marker. then i make another mark about 1 to 1.5" inside of that line and that is what I cut. That way you have a pretty tight fit without a lot of metal protruding from behind the fender flare when you are done. You just need enough for the rivets.