06-21-2011, 10:36 PM
Issue... so i made absolutely certian that my modified control arms were within 1/8" of each other in length, and they are. 1/16" to be exact, and i can dial in the length to be perfectly identical using the hiems.
My problem is that after bolting everything up good and tight, i have an alignment problem. In an effort to get it close for the time being, i measured in an X from the drivers front to passenger rear, and vice versa. the measyrements were off by almost an inch. not good... after scrathcing my head for a minute, i noticed that the front axle was sitting significantly to the drivers side. i am running the Toms 3.5" lift, which included a track bar drop bracket which is currently installed. it seems like the drop bracket isnt enough, and my trackbar is still too short.
This trackbar issue seems to be throwing off any hope of getting her lined up right. i am thinking of cutting and sleeving the track bar to make up a couple of inches (after some precision measurement of course) i know this is not as good as just ordering some heims and making an adjustable track bar, but i think that may be overkill. open to suggestions though...
So, am i on the right track? ( no pun intended) haha!
My problem is that after bolting everything up good and tight, i have an alignment problem. In an effort to get it close for the time being, i measured in an X from the drivers front to passenger rear, and vice versa. the measyrements were off by almost an inch. not good... after scrathcing my head for a minute, i noticed that the front axle was sitting significantly to the drivers side. i am running the Toms 3.5" lift, which included a track bar drop bracket which is currently installed. it seems like the drop bracket isnt enough, and my trackbar is still too short.
This trackbar issue seems to be throwing off any hope of getting her lined up right. i am thinking of cutting and sleeving the track bar to make up a couple of inches (after some precision measurement of course) i know this is not as good as just ordering some heims and making an adjustable track bar, but i think that may be overkill. open to suggestions though...
So, am i on the right track? ( no pun intended) haha!
My Build Thread-
http://www.carolinabroncos.com/forums/sh...php?t=3919
You're gonna have to be more specific... 11/12/11
http://www.carolinabroncos.com/forums/sh...php?t=3919
You're gonna have to be more specific... 11/12/11