09-19-2011, 03:39 PM
...lets see...
saturday started with swapping 3rds from chuzies rig to mine. his had 3.50/lock rite, while in there we noticed one axle shaft bearing was bad. we replaced axle seals and bearings-that finished mine.
then began assembling mike's new 31 spline chromos(lugs/bearings) rebuild my old 3rd with a new yukon grizzly locker and 4.56 gears, also installed a nice diff guard from "purple cranium products"...that took us into sunday morning 2am.
sunday began round 1pm and started complete disassemble of d44. assembled new chromo shafts, new 4.56's, and diff guard from same company. all said...2am once again.
as usual we ran into some issues(ie. lock ring for axle bearing,thinker ears on shafts making ujoints hard to install safety clip,yada, yada,yada
...long azz weekend
saturday started with swapping 3rds from chuzies rig to mine. his had 3.50/lock rite, while in there we noticed one axle shaft bearing was bad. we replaced axle seals and bearings-that finished mine.
then began assembling mike's new 31 spline chromos(lugs/bearings) rebuild my old 3rd with a new yukon grizzly locker and 4.56 gears, also installed a nice diff guard from "purple cranium products"...that took us into sunday morning 2am.
sunday began round 1pm and started complete disassemble of d44. assembled new chromo shafts, new 4.56's, and diff guard from same company. all said...2am once again.
as usual we ran into some issues(ie. lock ring for axle bearing,thinker ears on shafts making ujoints hard to install safety clip,yada, yada,yada
...long azz weekend
77 built 306,Trickflow Cam/Alum Heads/dome pistons/10:1comp,nv3550,duff long arms,3.5" lift,family cage,protofab rear bumper,twin sticked, and 35KM2'sG.D.I.