11-30-2011, 01:07 AM
Matt unfortunately there is not much you can do with the 170/200 head since the intake and head are cast as one part. I have read on ford 6 and in the hand book that you can get an Aussie head and intake that are separate for $$$$ of course.
The engine that is in it now was bought new and the casting numbers say it came out of a 68/69 Falcon if I remember right. So that is where I would start looking for carb info.
the 200 came out of an 82 (I think ) Merc. Zeph.
You can get a carb adapter from here http://www.cliffordperformance.net/ along with other goodies.
Fordsix does have a Bronco section that I have a few posts in, have not been there in years.
Hope some of this helps.
The engine that is in it now was bought new and the casting numbers say it came out of a 68/69 Falcon if I remember right. So that is where I would start looking for carb info.
the 200 came out of an 82 (I think ) Merc. Zeph.
You can get a carb adapter from here http://www.cliffordperformance.net/ along with other goodies.
Fordsix does have a Bronco section that I have a few posts in, have not been there in years.
Hope some of this helps.