Ms Piggy. Black and Blue!

[broncosbybart]

Both sides are in the same position. Must be the angle. I'm not set on the coils yet. The ones in there at the moment are 3.5" Duff's coils but I have been back and forth between those and the 4.5" WH coils I started with. Not sure which ones will end up being used yet.


Jumping around a bit, I cut the 70 grille up a little bit for the 67 turn signal mod. As well, I went for some creativity points on the rear shock mounts. Might have went a little overboard.

Then, out came the engine, trans, and transfer case. Got the front crossmember and driver side frame rail notched for harmonic balancer and starter clearance. The starter should clear without the notch, but I wanted to be sure.

While there, I welded up the engine mounts as well.