11-16-2012, 09:42 PM
I may have missed out on the URE run but I have been busy, I fixed the damage to the new frame, added a brace for the steering box, cut off the stock shock mounts, blasted it. I picked up some special inside frame paint and a gun to shoot it inside the frame. I also ordered a rust treatment paint (just like Por15). It comes in colors so I went with gray (like the bumpers). I will also use that paint on the underside of the tub.
The only thing this tub needed was hinge posts, I cut off the drivers side and welded the new one in. I realy should have done this when i put the new rockers in, especialy since I had to just about remove them to get the hinge post in.
I have cut off the pass side and am working on the reassembly. The next thing is to clean up some spots on the windshield frame and the front clip. I need to cut out the rad support for all my coolers. Then its going out side to be blasted.
I'm going with fiberglass rear fender flares, I want to try the new epoxie's that are out for bonding body pannels insted of the usual rivets. I will let you know how it comes out.
More to come....
The only thing this tub needed was hinge posts, I cut off the drivers side and welded the new one in. I realy should have done this when i put the new rockers in, especialy since I had to just about remove them to get the hinge post in.
I have cut off the pass side and am working on the reassembly. The next thing is to clean up some spots on the windshield frame and the front clip. I need to cut out the rad support for all my coolers. Then its going out side to be blasted.
I'm going with fiberglass rear fender flares, I want to try the new epoxie's that are out for bonding body pannels insted of the usual rivets. I will let you know how it comes out.
More to come....
[SIGPIC][/SIGPIC]