10-05-2013, 09:34 PM
(This post was last modified: 10-05-2013, 09:54 PM by broncosbybart.)
Thank you!
Got some more work done. I think I remember where I left off here. I've been spending an hour or two after work working on it when I get a chance.
All the misc. unused holes in the firewall were filled. The lower sections of the kick panels were cut for tire clearance. I fabbed up some sheet metal and welded it in place to make a more stock appearing panel that still has plenty of clearance over the stock panel. This was done for each side.
The rear shock buckets were fabbed from sheet metal, welded and ground smooth. They aren't huge and don't take up too much space in the bed.
Got some more work done. I think I remember where I left off here. I've been spending an hour or two after work working on it when I get a chance.
All the misc. unused holes in the firewall were filled. The lower sections of the kick panels were cut for tire clearance. I fabbed up some sheet metal and welded it in place to make a more stock appearing panel that still has plenty of clearance over the stock panel. This was done for each side.
The rear shock buckets were fabbed from sheet metal, welded and ground smooth. They aren't huge and don't take up too much space in the bed.