02-08-2014, 11:31 PM
Went down to the garage today for a bit to bend some more tube. Got the rear tube bent and fit into place.
Next, I worked on the front cage legs. In my haste, the very first bend I did on the driver's side tube was wrong. I ended up cutting the tube by the notch and adding a few inches to it, just to use it for mock up. After a little head-scratching and re-thinking, I bent the passenger side tube up without issue. I began to think about running the cage through the dash, but in the end logic prevailed. Hopefully I will be able to finish the bones of the cage up sometime soon.
Next, I worked on the front cage legs. In my haste, the very first bend I did on the driver's side tube was wrong. I ended up cutting the tube by the notch and adding a few inches to it, just to use it for mock up. After a little head-scratching and re-thinking, I bent the passenger side tube up without issue. I began to think about running the cage through the dash, but in the end logic prevailed. Hopefully I will be able to finish the bones of the cage up sometime soon.