02-17-2014, 01:08 AM
After that, I cut and notched some tubes to go diagonally from the main hoop to the rear hoop. About that time, a guy came by to look at the engine/trans/t-case that I had for sale. I started it up and backed it out of the garage so he could check it all over. He ended up buying it, which is great! Now I can begin the process of pulling all that stuff out to make room for the 4BT!
While it was out, I took a few pics so you guys can get an idea of how it looks so far. I think you'll get the idea of the direction it is heading. Not too elaborate, but should be plenty strong when finished.
While it was out, I took a few pics so you guys can get an idea of how it looks so far. I think you'll get the idea of the direction it is heading. Not too elaborate, but should be plenty strong when finished.