03-25-2014, 12:23 AM
Got some more work done on the front end. The front spring buckets are located and tacked on the radius arm brackets. I will drill the coil buckets and use bolts when I'm sure of the locations.
Also worked on the lower track bar mount, using a WH track bar riser. I made a box bracket out of 1/4" wall 2x4 to give the bracket additional support to rest against.
Then, fun and games drilling the provided bolt for the cotter pin. Always a good time.
Now, the track bar is parallel with the drag link, albeit a lot shorter than the drag link is.
Also worked on the lower track bar mount, using a WH track bar riser. I made a box bracket out of 1/4" wall 2x4 to give the bracket additional support to rest against.
Then, fun and games drilling the provided bolt for the cotter pin. Always a good time.
Now, the track bar is parallel with the drag link, albeit a lot shorter than the drag link is.