what have you wrenched on your bronco(s) today?

[wepuckett]

Well I have a cheap impact but borrowed a snapon from a mechanic buddy and still didn't do the trick. All I have is a propane torch and I could tell sitting there wasn't doing much to the bolt or the radius arm. As for the breaker bar my problem isn't the length of the breaker bar it is the fact the wrench I slip it over to pry on is bending every time because the bolt is too tight. As for breaking them I could go for that if I could get a clean break as I have a fealling I will be getting new radius arms and bolts when I order all new suspension later on. If it wasn't for the fact this is my front axle with disc brakes I would just leave it lie in the corner and not worry about it, but it is so I have to find some way to get them off. Even if the suspension kit doesn't come with bolts or a radius support arm I think I will be ok by pulling a couple bolts and a radius support arm off the other front axle I will be disasembling soon.

So I guess the ? now is how to get a clean break on the bolt so I can get the front radius support arm off.