09-09-2014, 10:03 PM
(This post was last modified: 09-09-2014, 10:08 PM by broncosbybart.)
Jay, you need a few of us to do a mini-wrenching day at your place?
Been working like a madman. Getting Chipper ready for a weekend excursion up to Asheville for the fall cruise on the 20th.
Here is a progress report:
- got the glove box opening cut into the dash and attached the cut out section from an original dash into place.
- got a new compliment of Autometer ultralight gauges and fit them into place.
- cleaned up a ton of wiring on the back side of the dash panel adn wired up the new gauges.
- installed a new Summit racing heater box and ductwork. After a lot of looking and planning, I realized a stock heater box just wouldn't fit. This one should work very well and the fan blows a lot of air. I didn't fab up any kind of selector. One outlet just goes to the cab, the other is ducted to the windshield
Drilling stainless is not much fun!
Been working like a madman. Getting Chipper ready for a weekend excursion up to Asheville for the fall cruise on the 20th.
Here is a progress report:
- got the glove box opening cut into the dash and attached the cut out section from an original dash into place.
- got a new compliment of Autometer ultralight gauges and fit them into place.
- cleaned up a ton of wiring on the back side of the dash panel adn wired up the new gauges.
- installed a new Summit racing heater box and ductwork. After a lot of looking and planning, I realized a stock heater box just wouldn't fit. This one should work very well and the fan blows a lot of air. I didn't fab up any kind of selector. One outlet just goes to the cab, the other is ducted to the windshield
Drilling stainless is not much fun!