12-09-2014, 10:22 PM
Here the lower mounts are being drilled for the 2 studs in the lower portion of the motor isolators.
Then, the assembly tack welded to the frame rail on the driver's side. Next is a handy dandy USPS box being recycled into a template for fabricating the upper plate on the pass side.
There was a lot of cutting, grinding, and fitting taking place here. All the material used has been 1/4" thick mild steel. It should hold...
Then, the assembly tack welded to the frame rail on the driver's side. Next is a handy dandy USPS box being recycled into a template for fabricating the upper plate on the pass side.
There was a lot of cutting, grinding, and fitting taking place here. All the material used has been 1/4" thick mild steel. It should hold...