03-12-2015, 10:47 PM
(This post was last modified: 03-12-2015, 10:54 PM by broncosbybart.)
Been busy installing some stamped steel upper quarter panel guards. They needed to be cut to length and I am planning to install them by bolting them to the quarters and have started locating the holes for the soft top along the bed rails.
Started on another project too, got the WH warflares fit up and installed. Those flares don't come with any dimples as a guide for drilling. I ended up using masking tape as a guide and marking off 3" spacing for the screws, which turned out pretty good. They were all longer than what I ended up cutting the body at. Nothing the angle grinder couldn't fix. The residue that came from cutting them looked exactly like spider webs.
Started on another project too, got the WH warflares fit up and installed. Those flares don't come with any dimples as a guide for drilling. I ended up using masking tape as a guide and marking off 3" spacing for the screws, which turned out pretty good. They were all longer than what I ended up cutting the body at. Nothing the angle grinder couldn't fix. The residue that came from cutting them looked exactly like spider webs.