04-13-2015, 04:59 PM
Fixed my rear pinion support leak. The O-ring was fine but the flange that supports the O-ring was chipped. This was likely due to me getting overzealous during a previous install.
JB Weld was perfect for this fix. Let it set for 24hrs and cleaned it up with various files. Perfecto!
Changed a failing u-joint on the front driveshaft.
Lubricated all my joints.
Made sure everything was tight in preparation for Tellico.
Got a new sponsor. ;-)
Sent from my GS3 on Cyanogenmod with the older / better version of Tapatalk!
JB Weld was perfect for this fix. Let it set for 24hrs and cleaned it up with various files. Perfecto!
Changed a failing u-joint on the front driveshaft.
Lubricated all my joints.
Made sure everything was tight in preparation for Tellico.
Got a new sponsor. ;-)
Sent from my GS3 on Cyanogenmod with the older / better version of Tapatalk!
'77 351w- Explorer EFI, 4R70W, 4-link, lockers, 4.56, 35" MT/Rs with a severe rock addiction.
mokin:
Roads? Where we're going, we don't need roads.
![[Image: sig2.jpg]](http://i288.photobucket.com/albums/ll176/mchuzie/sig2.jpg)
mokin:Roads? Where we're going, we don't need roads.