04-23-2015, 09:50 PM
Twwin Stick is in and so sweet, It took about 3 hours start to finish. I removed the shift levers on the tranny to allow a little more access to the slot in the Transfer case which had to be cut. I then removed the old J shifter, the original shifter hole in the tunne; was a oval about 2 1/2x5 inchs. I used the grinder with cutting disc to open this up another 2 1/2x 5 so now this is a 5x5 access right above the part which had to be modified on the case. I then cut it abd installed new twin stick and the new patch panel which came with the shifter and then the boot and the tranny shift arms. the hardest part was laying up in the seat sideways to reach everything. I hope Duffs will send the correct shifter knobs when I call tomorrow. The threads on the levers appear to be 7/16ths and the knobs they sent are 3/8ths. Also readjusted the clutch while I was under there.