what have you wrenched on your bronco(s) today?

[Crawdad]

I pretty much finished the first phase of my rotisserie build. I need some tabs to hold the top lip of the four frame corners. I'll do that tomorrow while I'm at Drill. It's a bear to turn by myself, it's all could do to get it at 45 degrees. The weight is not concentric so that's the biggest issue. But any higher I'm gonna need a ladder. Phase 2 I will beef it up with some 3/16" tubing and drop the pivot point and make it adjustable. The width right now is 53" but the next step is to add tubing underneath and make it 66" wide for stability. I plan to bolt that wider stance on and it too will have wheels. The bronco frame is apprx 13' long so I will add 13' of tubing on each side to connect the two ends. Again, those will be bolted on as well. My end result is to have a "convertible" rotisserie. Mine can be unbolted easily for transport, and for maneuverability around the garage.