Ms Piggy. Black and Blue!

[broncosbybart]

Seat heaters came from Summit Racing and are made by Rostra. They are for both the seat base and backs. I guess I forgot to take pics of the whole process.

The turbo is pretty much together. Had to modify the oil drain line (again). Next step is the intercooler and modifying the core support to mount it. I ended up getting some 1x1.5" rectangular tube to reinforce the core support and to mount the intercooler and radiator off of.

First thing I did was to cut the upper tube to length and then weld some 1/4" nuts flush into it. This is where the upper support tabs from the intercooler will mount to. I capped the ends of the tube and tacked it into place.

Next I cut the lower tube to fit. I had to cut some pockets into the lower tube for the intercooler mounts. The pocets were finished and sleeved as the mounting bolts on the lower tube will install from the bottom and go through the cross section of the tube. Then the tube ends were capped and it was tacked into place.

After that I worked on making the radiator mounts. I will reuse the lower brackets that were cut off of the core support. The upper radiator mounts will be reused as well.