09-18-2010, 03:33 PM
Chuck, Here you go.
Pic 1 = mounted on top of the pumpkin. There is a 1/4" plate welded to the top, I didn't think the housing steel was enough for the stress the anti-wrap would put on it. the tabs are welded to the plate.
Pic 2 = tabs welded to a square tube welded to the frame. The anti-wrap bar follows the line the Drive Shaft takes.
Pic 3 = different view of the pumpkin mount.
Pic 4 = Where I mounted the square tube to the frame and it is also welded to the body mounts. the tube is a 2"x2" 1/4" wall
Nick
Pic 1 = mounted on top of the pumpkin. There is a 1/4" plate welded to the top, I didn't think the housing steel was enough for the stress the anti-wrap would put on it. the tabs are welded to the plate.
Pic 2 = tabs welded to a square tube welded to the frame. The anti-wrap bar follows the line the Drive Shaft takes.
Pic 3 = different view of the pumpkin mount.
Pic 4 = Where I mounted the square tube to the frame and it is also welded to the body mounts. the tube is a 2"x2" 1/4" wall
Nick
'73 Bronco - trail modified