10-14-2015, 06:41 PM
Continued working on my hydraulic cylinder install. Ended up fabricating taller brackets to mount to the tie rod in a effort to achieve parallel between the tie rod and the cylinder. Everything is pretty close tolerance but will work just fine. I clocked the tie rod ends to reduce tie rod roll and will tack the jam nuts once I confirm my alignment is within spec.
I need to have some longer hoses made tomorrow and find some UHMW rod or tube to install internally to limit ram travel to 6.25" as I do not have the typical 8" throw most folks have.
I need to have some longer hoses made tomorrow and find some UHMW rod or tube to install internally to limit ram travel to 6.25" as I do not have the typical 8" throw most folks have.
'77 351w- Explorer EFI, 4R70W, 4-link, lockers, 4.56, 35" MT/Rs with a severe rock addiction.
mokin:
Roads? Where we're going, we don't need roads.
![[Image: sig2.jpg]](http://i288.photobucket.com/albums/ll176/mchuzie/sig2.jpg)
mokin:Roads? Where we're going, we don't need roads.