02-23-2016, 11:00 PM
Ran out of room on the dash! Got the digital Tiny Tach mounted on the wiper motor assembly. The ARB switches had to go under the dash. Both of them are wired up and I checked over the function of the ARB's and compressor. All works as it should!
Seats and belts are in, radio is wired, and exhaust is pretty well tacked in place. Plans are to get it all TIG welded- which I'll have to farm out. I wanted to have the exhaust tip near the quarter panel rather than to have it hanging down in the middle of nowhere. It looks a little funky from the back of the truck but it works. The rear bumper is sitting there to make sure everything will work together. Plans are to fab up/add a spare tire carrier to the rear bumper, but that is yet to come.
Seats and belts are in, radio is wired, and exhaust is pretty well tacked in place. Plans are to get it all TIG welded- which I'll have to farm out. I wanted to have the exhaust tip near the quarter panel rather than to have it hanging down in the middle of nowhere. It looks a little funky from the back of the truck but it works. The rear bumper is sitting there to make sure everything will work together. Plans are to fab up/add a spare tire carrier to the rear bumper, but that is yet to come.