07-06-2016, 04:23 PM
Take a look at my build thread, the last pics I put you can see a fiberglass hood scoop from Jeffs on there. Its facing backward and there is a hole cut in th
hood for air flow. The air filter base is mounted to a sheet of 1/8" aluminum. Foam about 2 inches thick on the edge of the sheet makes the hood seal around
the air filter housing. The steel one is a new peice, you will have to measure the hole size you need to cut and see if the scoop is wide enough.
Or you can try and find a drop base for the air cleaner, this can be done with a thinner air filter. I felt it restricted my engine too much.
hood for air flow. The air filter base is mounted to a sheet of 1/8" aluminum. Foam about 2 inches thick on the edge of the sheet makes the hood seal around
the air filter housing. The steel one is a new peice, you will have to measure the hole size you need to cut and see if the scoop is wide enough.
Or you can try and find a drop base for the air cleaner, this can be done with a thinner air filter. I felt it restricted my engine too much.
[SIGPIC][/SIGPIC]