04-29-2008, 08:40 PM
Well I finally was able to pick up the torque converter to flexplate adapter.
I will have approximately .050" pullback on the torqueconverter after install...hope that is okay.. Attached are a couple of photos of it.
Now I just need to pick up (4) high tensile strength 3/8-24 12point or (hex) nuts in the Charleston, SC area.. Lowe's has some grade 8 but in course not fine thread.. Any idea where I might purchase them in the area??? Could not find what I needed from Summit or Jegs... I hope to take a vacation day Friday and install the C4...
I will have approximately .050" pullback on the torqueconverter after install...hope that is okay.. Attached are a couple of photos of it.
Now I just need to pick up (4) high tensile strength 3/8-24 12point or (hex) nuts in the Charleston, SC area.. Lowe's has some grade 8 but in course not fine thread.. Any idea where I might purchase them in the area??? Could not find what I needed from Summit or Jegs... I hope to take a vacation day Friday and install the C4...
'77 EB, 2.5" SL, 2"BL, Cummins 4bt, C4 w/Art Carr manual Valve Body, 35" BFG KM2s
http://www.youtube.com/watch?v=M_HqhiW38ik
http://www.youtube.com/watch?v=M_HqhiW38ik