Posts: 1,716
Threads: 99
Joined: Dec 2007
Reputation:
0
chuzie Wrote:I am running dual FloFlos dumped in front of rears. It is pretty loud so if Bart is correct, I may consider moving my dump location. Chuck just installed a 2-1 and it is nice and quiet but still has a great sound. We can actually carry on a conversation in the cab at highway speeds.
I basically ended up using Nick H design since it sounds amazing. I ran 2 separate 2.50" pipes into a magnaflow muffler. Then ran one 3" pipe out in front of the passenger side rear tire. Came out great sounds good at idle and cruising up the road. I can also have a conversation in the cab with the doors off no problem.
68 Half cab
Posts: 4,530
Threads: 131
Joined: Nov 2005
Reputation:
0
Well done.
Sent from my GS3 on Cyanogenmod with T2.
'77 351w- Explorer EFI, 4R70W, 4-link, lockers, 4.56, 35" MT/Rs with a severe rock addiction. mokin:
Roads? Where we're going, we don't need roads.
![[Image: sig2.jpg]](http://i288.photobucket.com/albums/ll176/mchuzie/sig2.jpg)
Posts: 3,290
Threads: 141
Joined: Dec 2007
Reputation:
0
Starting to get ready for the Nov run. I am hoping to be all done within a week and not have to rush til the last minute!
Posts: 4,530
Threads: 131
Joined: Nov 2005
Reputation:
0
broncosbybart Wrote:Starting to get ready for the Nov run. I am hoping to be all done within a week and not have to rush til the last minute! Dream on buddy. We all fail when it comes to that. Nick H is the only exception.
Sent from my GS3 on Cyanogenmod with T2.
'77 351w- Explorer EFI, 4R70W, 4-link, lockers, 4.56, 35" MT/Rs with a severe rock addiction.mokin:
Roads? Where we're going, we don't need roads.
Posts: 3,290
Threads: 141
Joined: Dec 2007
Reputation:
0
No doubt. At least I'm planning toward a positive goal. Fingers crossed.
Posts: 4,530
Threads: 131
Joined: Nov 2005
Reputation:
0
Installed my Champion radiator today. My temps are higher on the interstate as opposed to my Ron Davis radiator so I am still looking at repairing it instead.
'77 351w- Explorer EFI, 4R70W, 4-link, lockers, 4.56, 35" MT/Rs with a severe rock addiction.mokin:
Roads? Where we're going, we don't need roads.
Posts: 1,716
Threads: 99
Joined: Dec 2007
Reputation:
0
Mine just needs the rock skis finished and hopefully the long arms will get on.
68 Half cab
Posts: 446
Threads: 44
Joined: Oct 2007
Reputation:
0
chuzie Wrote:Dream on buddy. We all fail when it comes to that. Nick H is the only exception.
Sent from my GS3 on Cyanogenmod with T2.
I must have you all fooled. I wrench quite a bit, although not as much as I used to have to just to keep it running. I have had to leave mine at home or at camp more than once because of issues, believe me, it has taken many years and quite a few wrenching weekends to get it where it is today, and it's never over. Just this past weekend, I replaced an exhaust header gasket and installed a new horn, it was a tough day in the garage upergrin:
Nick
'73 Bronco - trail modified
Posts: 4,530
Threads: 131
Joined: Nov 2005
Reputation:
0
Tried epoxy on the Ron Davis and still leaks. Bars Leaks liquid aluminum is my last hope of salvaging this expensive radiator. More to come.
'77 351w- Explorer EFI, 4R70W, 4-link, lockers, 4.56, 35" MT/Rs with a severe rock addiction.mokin:
Roads? Where we're going, we don't need roads.
Posts: 632
Threads: 21
Joined: Nov 2008
Reputation:
0
Egad!!! Radiator shop can't help?
:xyxthumbs: ROCKNROLL!!
|
