10-04-2007, 08:04 PM
Chill Chuck 8) , sip on a cool bevrage and then try again :twisted: .
When I swap full withs I reuse the track bar mounts on the axle. I measure where they were from the pass side raduis arm mount and then reweld them on the new axle in the same spot. As for the measurment for the lenth of the bar will depend on the hight of spring and how much drop you have on the frame. Keep in mind this will also center your axle so do this with the raduis arms loose and lubed well. Some times tighting the arms will twist and move the axle off center.
patience is a must, I put one in a ranger and screwed up the measuments :oops: . The thing drove like a crab.
hock:
Doing the dana 20 over is easy, and a good time to upgrade gears and the output shaft. I pan to upgrade mine this spring. Tired of wearing out the splines(hence why I travel with a spare).
Broncomatt
When I swap full withs I reuse the track bar mounts on the axle. I measure where they were from the pass side raduis arm mount and then reweld them on the new axle in the same spot. As for the measurment for the lenth of the bar will depend on the hight of spring and how much drop you have on the frame. Keep in mind this will also center your axle so do this with the raduis arms loose and lubed well. Some times tighting the arms will twist and move the axle off center.
patience is a must, I put one in a ranger and screwed up the measuments :oops: . The thing drove like a crab.
hock: Doing the dana 20 over is easy, and a good time to upgrade gears and the output shaft. I pan to upgrade mine this spring. Tired of wearing out the splines(hence why I travel with a spare).
Broncomatt
[SIGPIC][/SIGPIC]