Quick pin release for doors

[johnski]

ive done this. all i did was cut the pins out the stock door hinge. its been a while and i cant remember what size bolt i used, but i had to drill out the holes a little bit to get the new bolt to fit. then i just bolted it back up and aligned the door. i can get pics tommorow.

to remove the pins i just tap on them from the bottom and pull them out. i was going to drill a hole through the end of the bolt and put a pin through it to make sure it wouldnt come out, but thats not a issue. as far as wiring i just spliced some connectors on the speaker wires running through the door so i could easily unplug them.

its kinda a pain to take them off, there heavy, and the pins dont always like to come out easily.

also id check with local law enforcement before riding around with your doors off.

Did the exact same thing as JB. I tapered mine with the ol' angle grinder to make it easier to drop in. Here's some pics...