06-07-2009, 01:42 PM
I am going to build a full shroud for the two 10" electric fans I mounted on the front side of my Ron Davis Radiator for my '77. I did not mount the fans in direct contact with the radiator since it is aluminum so I need a shroud to make the fans effective.
Does anyone have any suggestions on type/ brands of fiberglass I should use? Is there a certain type of foam I should use for molding?
I have to do this for considerably less than the $90 RD wants to charge for their shroud.
Thanks,
Mike
Does anyone have any suggestions on type/ brands of fiberglass I should use? Is there a certain type of foam I should use for molding?
I have to do this for considerably less than the $90 RD wants to charge for their shroud.
Thanks,
Mike
'77 351w- Explorer EFI, 4R70W, 4-link, lockers, 4.56, 35" MT/Rs with a severe rock addiction.
mokin:
Roads? Where we're going, we don't need roads.
![[Image: sig2.jpg]](http://i288.photobucket.com/albums/ll176/mchuzie/sig2.jpg)
mokin:Roads? Where we're going, we don't need roads.