07-02-2009, 10:03 AM
I don't like to use adhesive on valve covers unless I have a contrary gasket. The silicone/rubber gaskets are the best. They can be reused and don't require constant re torquing. Cork are alright when that is what I have to work with. But I despise using yellow glue on them that so may people use. It make a it a pain clean and change the gasket later on.
If you are reusing the factory tin covers, check the area around the bolt holes. Look for small splits where the top rounds over to the lip mounting flange at the bolt holes. Also make sure that the mounting flange in not dimpled from over tightening. Use a socket and a small hammer to flatten things back to where they are supposed to be.
If you are reusing the factory tin covers, check the area around the bolt holes. Look for small splits where the top rounds over to the lip mounting flange at the bolt holes. Also make sure that the mounting flange in not dimpled from over tightening. Use a socket and a small hammer to flatten things back to where they are supposed to be.
'72 TBA...