12-04-2007, 04:17 PM
I pulled the top off again to load a bunch of wood to haul up to the shop.
A buddy was "borrowing a bay" to put bed liner in his jeep(which translated into, help me put bedliner in my jeep) and I needed lots of wood too keep it warm.
It ran ok, but still hard to start. Finally got the correct oil pan, and repainted the replacement door pannel. So I was planning on some quick maitnece and back to work it would go. While preparing to bring it in the barn for this weekend I knoticed there was antifreeze on the starter.
Which explanes the constent coolent loss. I think it may have a bad headgasket. For now i pan to do what I can this weekend(trans fluid change, new oil pan, strip bed, drivers inner door panne.
I also need to figure out which wheel cyl is leaking, I think I have one of those too.
I am realy starting to like this truck, I think a title will be the next priority.
Broncomatt
A buddy was "borrowing a bay" to put bed liner in his jeep(which translated into, help me put bedliner in my jeep) and I needed lots of wood too keep it warm.
It ran ok, but still hard to start. Finally got the correct oil pan, and repainted the replacement door pannel. So I was planning on some quick maitnece and back to work it would go. While preparing to bring it in the barn for this weekend I knoticed there was antifreeze on the starter.
Which explanes the constent coolent loss. I think it may have a bad headgasket. For now i pan to do what I can this weekend(trans fluid change, new oil pan, strip bed, drivers inner door panne.
I also need to figure out which wheel cyl is leaking, I think I have one of those too.
I am realy starting to like this truck, I think a title will be the next priority.
Broncomatt
[SIGPIC][/SIGPIC]