10-31-2009, 11:23 PM
well, just the keep the thread current...started running the fuel lines and wiring Fri night. Chuzie came by and we were at the point to fire the motor up, but the motor wouldnt turn. it was bound up! so this morning i began removing the trans...still the motor wouldnt turn. so i took the bell housing off and BINGO! the motor turns, so i found the pressure plate scrapping the bell housing. i ground the housing and some off the bolt areas on the pressure plate...everything turns good now. a buddy came by to help install the tranny. Sunday comes...she will run! ill keep yall posted
77 built 306,Trickflow Cam/Alum Heads/dome pistons/10:1comp,nv3550,duff long arms,3.5" lift,family cage,protofab rear bumper,twin sticked, and 35KM2'sG.D.I.